Therefore, it is wise to save the project settings again after completing the audiobook creation in order to use the AAC file directly in case of a recompilation.When using an MP3 or a WAV file as starting material, the file extension is changed to *.m4a after completion of the conversion to an AAC file.In conclusion, the entire project can be saved with this also applies for the "Status Messages" area.in AAC Audiobook Creator, paths are given relative to the path defined in "Sources" whenever possible.The program informs about the progress of creation in the area "Status Messages".Īs for the actual audiobook compiling an external command-line program is used, status messages are not continuously displayed. "Stop" cancels the compilation process at any time (since Version 2.1).ĭepending on the computing power, this process may take several minutes. Now, the audiobook compilation can be started with by using the file property "Duration" the other value is adjusted by the program independently.in the example shown above, the chapter number is specified) information on the number and duration of any chapter are only possible alternative (e.g.The program will request necessary but missing information by itself. Caption: Enter here how chapters shall be named (example: the entry "Chapter" will lead to Chapter 1, Chapter 2.Offset: Use this slider to determine the time between two chapters (this creates a chapter every x minutes).Chapters: Use this slider to determine the number of desired chapters.AAC File: Enter here path and name of the single source AAC audio file (*.m4a).The inclusion of the chapter file can be defined in the "Single AAC File based Project" area:
0 Comments
Leave a Reply. |